Filter
Top Products
15
2011 July
700r-NA
4-SPECIFICATIONS (continued)
Specifications
4.6 Tape Roll Diameter
Up to 405mm [16 inch] maximum on a 76mm [3 inch] diameter core.
(Accommodates all system roll lengths of Scotch
®
fi lm tapes.)
4.7 Tape Application Leg Length – Standard
70mm ± 6mm [2 3/4 inch ±1/4 inch]
Tape Application Leg Length – Optional
50mm ± 6mm [2 inch ±. 1/4 inch]
(See "Removing Taping Heads Procedure – Changing the Tape Leg Length")
4.8 Box Board
Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or double wall B or C fl ute.
23-44 lbs. per inch of width Edge Crush Test (ECT)
4.9 Box Weight and Size Capacities
A. Box Weight, fi lled: 5 lbs.– 65 lbs. [2.3 kg–29.5 kg]. Contents must support fl aps.
B. Box Size: Minimum Maximum
Length – 150mm [6.0 inch] Unlimited
Width – 150mm [6.0 inch]* 550mm [21.5 inch]
Height – 120mm [4.75 inch]** *** 620mm [24.5 inch] ***
* Cartons narrower than 250mm [10 inch] in width may require more frequent belt replacement
because of limited contact area.
** 95mm [3.75 inch] height with heads adjusted to apply 50mm [2 inch] tape leg lengths.
(See "Special Setup Procedure—Changing the Tape Leg Length".)
*** 200mm [8.0 inch] minimum to 725 mm [28.5 inch] maximum height with columns adjusted to upper
position. (See "Special Setup Procedure".)
Note: The case sealer can accommodate most boxes within the size range listed above. However, if the box
length (in direction of seal) to box height ratio is 0.6 or less, test run several boxes to ensure proper
machine performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL = SHOULD BE GREATER THAN 0.6
BOX HEIGHT
Any box ratio approaching this limitation should be test run to ensure performance.