Filter
Top Products
44
13-MAINTENANCE AND REPAIRS (continued)
13.10 Box Drive Belt Tension
The four (4) continuously moving drive belts convey boxes through the tape applying mechanism.
The box drive belts are powered by an electric gear motor.
Tension adjustment of these belts may be required during normal operation. Belt tension must be adequate
to positively move the box through the machine and the belts should run fully on the surface of the pulleys at
each end of the frame. The idler pulleys on the infeed end are adjusted in or out to provide proper belt tension.
Each belt is adjusted separately.
Belt tension is obtained by tightening the adjustment screw so that a moderate pulling force of 3.5kg [7 lbs.]
applied at the mid-span, as shown in Figure 13-7, will defl ect the belt 25mm [1 inch]. This will assure positive
contact between the belt and the drive pulley on the discharge end of the drive assembly.
Figure 13-7 Box Drive Belt Tension Adjustment
• To reduce the risk associated with mechanical and electrical hazards:
Turn electrical and air supply off and disconnect before performing any adjustments,
maintenance or servicing the machine or taping heads.
Discharge End Infeed End
3.5kg (7 lbs) Pull Force
with 25mm (1 inch) at Mid-span
Box Drive Belt
WARNING
2011 July
700r-NA
13.9 Drive Pulley Rings
Before installing a new belt, check the orange plastic
drive pulley rings for wear. If torn, broken, or worn
smooth, replace the rings (Figure 13-6).
Figure 13-6