Filter
Top Products
11 - SET UP AND ADJUSTMENTS (continued)
38
2011 July
700r-NA
Figure 11-5
Note – The upper head has a unique feature for
overstuffed boxes. The head will raise up
to 13mm [0.5 inches] to compensate for
this condition.
11.5 Run Boxes to Inspect Adjustment
(Figure 11-5)
Turn electrical and air pressure switches to On. This
starts the drive belts and engages the pneumatic air
pressure system. Move box forward until it contacts
the Side Guides Centering Switch in the machine
bed which automatically center the box. Continue
moving the box forward until it contacts the Upper
Drive Assembly Actuator Switch. The Upper Drive
Height adjustment adjusts automatically as the box
is taken away by the drive belts. Always push at the
end of the box. If the box is not centered correctly
or the Upper Drive Assembly does not contact the
top of the box correctly, see pressure adjustment
settings and/or the Troubleshooting Section.
Important: Before starting the machine, verify that
no tools or other objects are on the conveyor bed.
Important – If drive belts are allowed to slip on
box, excessive belt wear will occur.
Note - For belt replacement and tension
specifi cations - refer to
Section 13 / Maintenance and Repairs.
• To reduce the risk associated with
pinch hazards:
Keep hands clear of the upper head support
assembly as boxes are transported through
the machine.
Keep hands, hair, loose clothing, and jewelry
away from box compression rollers.
Always feed boxes into the machine by
pushing only from the end of the box.
Keep hands, hair, loose clothing, and jewelry
away from moving belts and taping heads.
CAUTION