Filter
Top Products
27
700r-NA
2011 July
Pressure Regulator regulates main air
pressure to the machine to adjust pressure, pull
knob up and turn – push down to lock setting.
Filter removes dirt and moisture from plant
air before it enters the case sealer pneumatic
circuits. If water collects in bottom of bowl, lift
up on the valve on the bottom of bowl to drain.
3. Emergency Stop Switch
The machine electrical supply can be turned
off by pressing the latching emergency stop
switch. To restart machine, rotate emergency
stop switch (releases switch latch) and then
restart machine by pressing green (On) button
on side of machine frame.
4. Raising Switch, Upper Drive Assembly
This switch, when touched by the leading
edge of a box, pneumatically raises the upper
frame to allow insertion of the box under the
drive belts. As the box moves under the switch,
releasing it, the upper drive assembly descends
on the box and the drive belts convey the box
through the machine. When switch is actuated
by hand, the upper drive assembly rises to its
maximum height. Released, the upper drive
assembly descends to its rest position.
5. Centering Switch, Box Centering Guide
This pneumatic switch controls the box
centering guides. When switch is activated
by a box entering the case sealer, the
centering guides close (centering the box),
and released (after box passes over switch),
the guides open.
6. Air Pressure Regulator, Centering Guide
Force Adjustment – Figure 7-16
This regulator is used to adjust centering
guides according to weight of boxes.
Pressure should be adequate to center
boxes, but low enough to allow easy
pushing of boxes under taping head.
The regulator setting can be locked by
tightening the phillips screw as shown.
Figure 7-17 – Air Regulator/Gauge, Top Drive
Assembly
Figure 7-16– Air Regulator, Centering Guides
7. Air Pressure Regulator/Gauge, Top Drive Assembly Force Adjustment – Figure 7-17
Set nominally to control "down" movement of top drive assembly and the pressure exerted against the box.
The regulator setting is changed as necessary for the boxes being sealed to provide adequate drive belt
pressure against the box to positively convey the boxes through the machine. If the boxes stop or hesitate
while being conveyed, decrease the regulator pressure which will increase the drive belt force on the box
for more friction between the box and drive belts. Adjust setting as necessary to get continuous movement
of boxes through machine.
7-INSTALLATION AND Setup (continued)
Locking Nut