Filter
Top Products
Adding a Network Set
EncrypTight User Guide 171
Key Management
System
Select the desired Key Management System from the Default ETKMS
list. You must select a ETKMS even if the network set does not include
a PEP. If you create a policy that includes a network set that does not
have a ETKMS, you will not be able to deploy that policy.
Network Addressing
Mode
Select the desired network addressing mode. The network addressing
mode specifies the source IP address used in the packet header.
• Use Network IP Address (default) - original packet header
containing the network’s IP address is used for all outgoing packets.
• Use PEP’s Remote IP Address - the PEP’s remote port IP address
is inserted into the packet header for all outgoing packets. This
option is not available if the network set contains more than one
PEP.
• Use Virtual IP Address - the virtual IP address is inserted into the
packet header for all outgoing packets. If you select this option,
enter the IP address to use as the source address for outgoing
packets in the Virtual IP Address box.
Depending on the type of PEP selected and its configuration, some
options may not be available. ETEP PEPs preserve the original network
address by default and must be explicitly configured to use any other
mode. For more information on how to configure your PEP, see the
configuration chapter for your PEP.
For more information on network addressing modes, see “Network
Addressing for IP Networks” on page 35.
This setting can be overridden by settings in a policy. For more
information, see “Addressing Mode” on page 185.
Table 43 Network Set fields (continued)
Field Description