Filter
Top Products
22
USA
5958 931 01
Press the U button again so that the UTILITY changes colour
(GREEN flashing) and is thus cancelled.
- To cancel the other UTILITIES set another cooking cycle.
In case of cycle already started, stop it, keeping the START/
STOP button pressed for 2 seconds before cancelling the UTILITY.
4.3.9 PREHEATING
The oven chamber can be preheated if necessary before starting
the actual cooking cycle.
Start the oven with the chamber empty by setting:
- the desired cooking mode.
- preheating temperature on Thermostat TS.
- continuous cooking "cont" on Timer TM.
- wait for the oven chamber temperature display to show that the
preheating temperature has been reached.
- open the oven door and place the product to be cooked inside the
oven.
Important
! Risk of burns.
Open the door with due care when the appliance is hot.
- Close the door and set the desired cooking time on Timer TM
and, if necessary, adust cooking temperature on Thermostat TS.
4.3.10 UTILITIES
- Switch on the oven by pressing button I.
- Set a cooking cycle for the following UTILITIES:
UTILITIES with cycle presetting;
this is not necessary for the other utilities as they are already
specific cycles.
- Press button U (UTILITY):
U (UTILITY)
- The green UTILITY LEDs will light up and one will be flashing.
E.g.: UTILITY selected
(flashing GREEN LED)
- Turn the knob clockwise or counter clockwise to select the utility
required - the relative LED will flash (flashing GREEN color).
- Press button U until the flashing LED relative to the UTILITY
selected changes colour (flashing ORANGE color).
- Wait a further 5 seconds for the LEDs relative to the selected
utilities to illuminate steadily (steady ORANGE color).
- Finally, start the cycle by pressing the START/STOP button.
A complete description of the different UTILITIES available is
included in heading 3.4 SPECIAL COOKING MODES (page 20).
Note:
If the UTILITIES are not used for 7 seconds they are
automatically cut out, signalled by the relative button switching
off.
- To cancel one of the following preset UTILITIES (ORANGE
steady):
press the U button and turn the knob to select it so that it flashes
(ORANGE flashing).