Filter
Top Products
B - 6 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
B
Error Numbers in Internal USER Variable
The name of an internal user variable can be defined in the PLC Node Parameter Definition
window (see chapter 4). These variables are assigned the following error numbers:
Error Number Definition
24100 ... GENI Board OK Flag is not set
24101 ... Device present Flag of the respective station is not set (control switched off
or not connected)!
24102 ... DATAGRAM could not be set (Command Timer possibly set too low)!
24103 ... Datagram set with error (should never occur)!
24104 ... The defined PLC Type does not match with the connected slave!
24105 ... Lockout request not OK. Access to the global data does not function
(should never occur).
24106 ... Write command to READ Only Variable (with received Global Data) !
24107 ... Connection already established. Two DS_connect_req commands have
been sent to the same bus address.
24108 ... Write command to READ Only Variable (with received Global Data) !
24109 ... Timeout. The request to the respective station has not been answered
(Timeout time possible too short.) Occurs if the requested PV does not
exist in that station.
24110 ... VL amount exceeded. The number of defined VLs (PLC Node Parameter)
is too small.
24120 ... PV Name invalid (Check PV Name in PCS again)
24121 ... PV Offset not modulo 8. If a BIT variable is assigned to the PLC data type
WORD (M, I, ...), the offset must be according to the following formula:
(offset - 1) % 8 == 0
24122 ... PV Offset too high for Global Variable. Only occurs for Global Data, if the
offset is larger than is allowed by the "Broadcast control data length".
24123 ... Incorrect PV PLC data type (Should no longer occur)
24124 ... The entered PV Offset plus the length of the PC exceeds the allowed limits
of the variable type.