Filter
Top Products
3 - 28 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
3
Press the F4 Accept key to close the field and confirm it as part of the picture. The field should be
displayed within the picture as shown below:
Press the F10 Exit function key to end this picture editing session. Because this is a new picture, a
window will open to confirm whether or not the picture should be saved.
Type
Y
to request that the picture be saved, then type the desired filename (START-UP) using the
keyboard. The picture is saved under the name you type and assigned a .BIL extension
automatically when you press ↵↵.
Picture 3
An error picture that will display on any communication error is created in exactly the same way
as any other picture. Input or output fields that would access variables from the PLC are of no use,
however, because the error picture is supposed to show an error in communications. Internal
variables can be shown (e.g., error variables that are used to display the type of communications
error). See the PANELWARE™ Configuration Software Reference Manual (GFK-0849) for
details.
Using the steps followed to create the first two pictures, create the following error picture and save
it under the name ERROR:
The Output Bit/Byte field in the picture is defined as follows: