Open as PDF
You can adjust the rinse aid dosage for
The rinse aid dosage can be set from
approx. 0-6 ml.
The factory default setting is 3 ml.
If the function to adjust the Sensor wash
programme has been activated, the
amount of rinse aid dispensed in the
Sensor wash programme can be higher
than that set.
If spots appear on crockery and
– Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
– Decrease the rinse aid dosage.
^ Select the rinse aid dosage you want,
and confirm your selection with the
When the buzzer is activated, an
audible tone sounds at the end of a
programme and when there is a fault.
The buzzer is activated as standard at
Buzzer at the end of a programme
You will hear the buzzer at the end of a
programme. It will sound four times in
bursts of three beeps with a noticeable
pause (approx. 15 seconds) in
between. Switching the dishwasher off
will switch the buzzer off.
Buzzer when there is a fault
In the event of a fault, the buzzer will
sound four times in bursts of three
beeps with only a very short pause in
The buzzer which sounds if there is a
fault cannot be deactivated.
Setting the buzzer volume
There are seven different volume
settings. If no volume is selected, the
buzzer is deactivated.
Select the volume you want, and
confirm your selection with the