5. BASE SPECIFICATIONS PARAMETERS
II - 35
# Items Details Setting range (unit)
1095 T0tfof TF output Select how to handle TF for T00 command.
0: TF is output.
1: TF is not output
0/1
1096 T_Ltyp
(for L
system
only)
Tool life
management
type
Specify the tool life management type. 1: Life management
type l
2: Life management
type ll
1097 T1digt Tool wear
compensation
number
1-digit
command
Specify the No. of digits in the tool wear
compensation No. in the T command.
0: The 2 high-order digits are the tool No.‚ and
the 2 Iow-order digits are the wear
compensation No.
1: The 3 high-order digits are the tool No.‚ and
the 1 Iow-order digit is the wear compensation
No.
This parameter will be fixed to 0 when tool life
management II is selected.
0/1
1098 Tlno. Tool length
offset number
Specify the No. of digits in the tool length offset No.
in the T command.
0: The 2 or 3 high-order digits are the tool No.
The 2 or 1 Iow-order digits are the tool length
offset and wear compensation Nos.
1: The 2 or 3 high-order digits are the tool No.
and tool length offset Nos.
The 2 or 1 Iow-order digits are the wear
compensation No.
0/1
1099 Treset Cancel tool
wear compen-
sation amount
Specify how to handle tool compensation vector
when resetting system.
0: Clear the tool length and wear compensation
vectors when resetting.
1: Save the tool length and wear compensation
vectors when resetting.
When the values are cleared‚ the compensation will
not be applied‚ so the axis will move the
compensation amount in the next compensation
operation.
When the values are saved‚ the compensation will
be applied‚ so the axis will shift the differential
amount of the compensation amount in the next
compensation operation.
0: Clear
1: Save
