3. PROGRAM ERROR
I - 76
Error No. Details Remedy
P511 SYNC CODE ERR
• Two or more synchronization M codes
were commanded in the same block.
• The synchronization M code and "!" code
were commanded in the same block.
• Check the program.
P600 NO AUTO TLM.
An automatic tool length measurement
command (G37) was execute though
there are no such command
specifications.
• Check the specifications.
P601 NO SKIP SPEC.
A skip command (G31) was issued
though there are no such command
specifications.
• Check the specifications.
P602 NO MULTI SKIP
A multiple skipping command (G31.1‚
G31.2 or G31.3) was issued though there
are no such command specifications.
• Check the specifications.
P603 SKIP SPEED 0
The skip speed is 0.
• Specify the skip speed.
P604 TLM ILL. AXIS
No axis or more than one axis was
specified in the automatic tool length
measurement block.
• Specify only one axis.
P605 T-CMD IN BLOCK
The T code is in the same block as the
automatic tool length measurement
block.
• Specify this T code before the block.
P606 NO T-CMD BEFOR
The T code was not yet specified in
automatic tool length measurement.
• Specify this T code before the block.
P607 TLM ILL. SIGNL
Before the area specified by the D
command or decelerating area
parameter d‚ the measurement position
arrival signal went ON. The signal
remains OFF to the end.
• Check the program.
P608 SKIP ERROR (CC)
A skip command was specified during
radius compensation processing.
• Specify a radius compensation cancel (G40)
command’ or remove the skip command.
