5. BASE SPECIFICATIONS PARAMETERS
II - 64
# Items Details Setting range (unit)
1230 set02 Not used.
1231 set03
(bit1)
Switch graphic
coordinates
Select whether to draw graphics with the machine
coordinate value or the tool position coordinate value
(position being machined, obtained by subtracting
the tool compensation amount from machine
coordinate values) when displaying the trace
function.
0: Machine coordinate value (same as
conventional method)
1: Tool position coordinate value
The counter display and counter name are
sequenced with this.
0/1
set03
(bit2)
Switch graphic
check trace
Select whether to draw both the machine coordinate
value (tool center path) and tool position coordinate
value (program path) or draw only the coordinates
selected with switch graphic coordinates (#1231
set03/
bit1) when using the program check function.
0: Both machine coordinates and tool position
coordinates (same as conventional method)
1: Only coordinates designated with switch
graphic coordinates.
0/1
set03
(bit3)
Hold display
range
information
Select whether to hold the display range information
(drawing position and scale value) for graphic displays.
0: Hold.
1: Do not hold. (Initialize each time ... same as
conventional method)
0/1
set03
(bit4)
Switch zero
point mark
display position
Select what position the zero point mark in the
graphic display indicates.
0: Machine coordinate zero point (same as
conventional method)
1: Workpiece coordinate zero point
0/1
1232 set04
(bit0)
Switch load
monitor
Select whether to detect the load with the load
monitor's load detection, excluding during
acceleration/
deceleration.
0: Detect also during acceleration/deceleration.
(Conventional)
1: Do not detect during acceleration/deceleration.
0/1
set04
(bit1)
Program format
(IC card)
Select the format of the file output during copying
(NC → IC).
0: Add "%" to the head of the file.
1: The head of the file is No. 0.
0/1
