A SERVICE OF

logo

Open as PDF
next previous
5. BASE SPECIFICATIONS PARAMETERS
II - 49
# Items Details Setting range (unit)
1201
(PR)
G1_acc Validate
acceleration
and
deceleration
with inclination
constant G1
Set up acceleration and deceleration types when a
liner interpolation command is issued.
0: Acceleration and deceleration (conventional)
with time constant
1: Acceleration and deceleration with inclination
angle constant
0: Acceleration and
deceleration with
time constant
1: Acceleration and
deceleration with
inclination angle
constant
1202 mirofs
(For L
system
only)
Not used.
1203 TmirS1
(For L
system
only)
Not used.
1204 TmirS2
(For L
system
only)
Not used.
1205 G0bdcc Acceleration
and
deceleration
before G0
interpolation
0: G00 acceleration and deceleration are selected
as those after interpolation.
1: The G00 acceleration/deceleration is the
acceleration/decelerate before interpolation
regardless of whether the mode is the high
accuracy control mode.
0/1
1206 G1bF Maximum
speed
Set up a cutting feedrate when selecting
acceleration and deceleration before interpolation.
1 to 999999 (mm/min)
1207 G1btL Time constant Set up a cutting feed time constant when selecting
acceleration and deceleration before interpolation.
G1bF
G1btL
Time
Speed
1 to 5000 (ms)
1208 RCK Not used.