Filter
Top Products
11
PAge heAder.....
ASSEMBLY & OPERATION
4. Place the blending leg as deeply as
possible into the jug and press the
trigger switch to turn the immersion
blender on. The button must be held for
the required duration of operation.
5. Work through the ingredients in
the jug with a gentle raising and
lowering motion.
6. Turn the motor off by releasing the
trigger switch.
7. Ensure the motor has completely
stopped before lifting the blender out of
the jug.
8. When processing has finished remove
the power plug.
TO DETACH THE BLENDING LEG
Ensure the trigger switch is released and
the appliance is unplugged. Hold the motor
body with one hand, and using thumb and
finger of the other hand, press on the two
EJECT buttons on either side of the motor
body. Pull the motor body away from the
blending leg to detach.
RECOMMENDATIONS WHEN USING
AS AN IMMERSION BLENDER
• The immersion blender blends foods
and liquids rapidly, therefore it is easy
to over process. Remember when using
the blending leg to stop the immersion
blender and check food throughout the
operation.
• Allow food to cool before blending.
• The stainless steel blending leg allows
for hot food to be processed directly
in the saucepan. This makes blending
soups and sauces very easy.
• For safety reasons remove saucepan
away from the heat before processing.
• Ensure the body of the appliance and
power cord are kept away from any
heat source.
• When pureeing and blending, cut food
into uniform sizes. This will ensure
smooth and consistent results.
• Warm all liquids to be added to soups
and purees, this will ensure even
blending.
• Do not operate the appliance
continuously for more than 1 minute.
Allow the motor to rest for 1 minute
between each use.
If food becomes lodged around the
processing blade or in the blade guard,
follow the following safety instructions:
1. Release the trigger switch to power off
and unplug the cord.
2. Use a spatula to carefully dislodge the
food. Do not use fingers as the blades
are sharp.
3. After the food has been removed and
blades are clear, plug the appliance back
into the power supply and continue
blending.