Filter
Top Products
112
7
7
Figure 24
2. Remove retainer (A, Figure 24), return
spring (B), flat washer (C), wave washer
(D), pinion gear (E), and starter clutch (F).
Figure 25
Assemble Starter Motor Drive - C-Ring
Retainer
1. Place clutch on starter shaft
(A, Figure 25). Rotate clutch until it drops
into place (B).
Figure 26
2. Install pinion gear (C, Figure 26) with
beveled edge of teeth up. Install return
spring (D) into recess of pinion gear.
Figure 27
3. Place wave washer (E, Figure 27) with
concave side up and flat washer (F) on
starter clutch spline.