Filter
Top Products
13
1
1
Figure 13
Figure 14
Snow Hood
NOTE: Snow engines do not have an air cleaner
assembly. Instead, a 1-piece or 2-piece snow
hood is installed to protect the carburetor area,
retain heat to resist carburetor icing, and provide
a mounting surface for engine controls.
Remove
1. Remove choke knob (A, Figure 15 and
Figure 16).
2. Remove fasteners and hood (B).
3. Disconnect stop switch wire (C) and
primer hose (D).
Figure 15
Figure 16
Inspection
1. Check hood for cracks or worn mounting
holes. Replace if necessary.
2. Check primer hose for brittleness or leaks
and check stop switch and wire for
damage. Replace parts as necessary.
Install
1. Connect stop switch wire (C, Figure 15)
and primer hose (D).
2. Install hood and fasteners (B).
3. Install choke knob (A) with tab under knob
fitting into slot of hood. Actuate the choke
knob to check for proper movement.