Filter
Top Products
66
4
4
5. If necessary, remove two nuts from
bracket and slide bracket off cylinder head
studs.
Inspection
1. Clean gummy or dirty fuel tanks with
Briggs & Stratton Carburetor Cleaner
#100041 or #100042, or equivalent.
2. Inspect fuel tank for:
• Corrosion
• Leaks
• Broken mounting brackets
3. Check fuel cap and filler neck for:
• Proper seals
• Vents
• Functional quantity gauge (if equipped)
4. Check fuel filter for blockage of any kind.
5. Check fuel shut-off valve for proper
operation.
Clean or replace parts as required. Fuel filter
replacement is recommended annually or any
time the fuel system is serviced.
Installation
1. Slide mounting bracket (if removed) on
cylinder head studs. Install nuts and
torque to values listed in Section 12 -
Engine Specifications.
NOTE: Bracket is offset to allow clearance for
the intake manifold.
2. Position tank in bracket. Install two bolts
with spacers and torque to values listed in
Section 12 - Engine Specifications.
3. Assemble shut-off valve and fuel filter, if
equipped, to fuel hose.
4. Install hose assembly to fuel pump fitting
and secure with clamp, then install to tank
fitting and secure with clamp.
5. Partially fill tank with fuel and check for
leaks. Repair as necessary.