Filter
Top Products
Warranty (contd)
For warranty service or repair,
this product must be returned to
a service facility designated by
HP. Buyer shall prepay shipping
charges to HP and HP shall pay
shipping charges to return the
product to Buyer. However,
Buyer shall pay all shipping
charges, duties, and taxes for
products returned to HP from
another country.
HP warrants that its software
and firmware designed by HP
for use with an instrument will
execute its programming
instructions when properly
installed on that instrument. HP
does not warrant that the
operation of the instrument, or
software, or firmware will be
uninterrupted or error free.
Limitation of Warranty
The foregoing warranty shall not
apply to defects resulting from
improper or inadequate
maintenance by Buyer, Buyer-
supplied software or interfacing,
unauthorized modification or
misuse, operation outside the
environmental specifications for
the product, or improper site
preparation or maintenance.
NO OTHER WARRANTY IS
EXPRESSED OR IMPLIED.
HP SPECIFICALLY
DISCLAIMS THAT IMPLIED
WARRANTIES OR
MERCHANTABILITY AND
FITNESS FOR A
PARTICULAR PURPOSE.
Exclusive Remedies
THE REMEDIES PROVIDED
HEREIN ARE BUYER'S
SOLE AND EXCLUSIVE
REMEDIES. HP SHALL NOT
BE LIABLE FOR ANY
DIRECT, INDIRECT,
SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL
DAMAGES, WHETHER
BASED ON CONTRACT,
TORT, OR ANY OTHER
LEGAL THEORY.
Assistance
Product maintenance
agreements and other customer
assistance agreements are
available for Hewlett-Packard
products.
For any assistance, contact your
nearest Hewlett-Packard Sales
and Service Office.
Safety Considerations
(contd)
WARNING
ANY INTERRUPTION OF
THE PROTECTIVE
GROUNDING
CONDUCTOR (INSIDE
OR OUTSIDE THE
INSTRUMENT) OR
DISCONNECTING THE
PROTECTIVE EARTH
TERMINAL WILL CAUSE
A POTENTIAL SHOCK
HAZARD THAT COULD
RESULT IN PERSONAL
INJURY. (GROUNDING
ONE CONDUCTOR OF A
TWO CONDUCTOR OUT-
LET IS NOT SUFFICIENT
PROTECTION.)
Whenever it is likely that the
protection has been impaired,
the instrument must be made
inoperative and be secured
against any unintended
operation.
If this instrument is to be
energized via an
autotransformer (for voltage
reduction) make sure the
common terminal is connected
to the earthed pole terminal
(neutral) of the power source.
Instructions for adjustments
while covers are removed and
for servicing are for use by
service-trained personnel only.
To avoid dangerous electric
shock, do not perform such
adjustments or servicing unless
qualified to do so.
For continued protection against
fire, replace the line fuse(s) only
with 250V fuse(s) of the same
current rating and type (for
example, normal blow, time
delay). Do not use repaired fuses
or short circuited fuseholders.
Acoustic Noise Emissions
LpA 27 dB at operator position,
at normal operation, tested per
EN 27779. All data are the
results from type test.
Geräuschemission
LpA 27 dB am Arbeits platz,
normaler Betrieb, geprüft nach
EN 27779. Die Angagen
beruhen auf Ergebnissen von
Typenprüfungen.
Continued from front matter . . .