Filter
Top Products
Viper Service Manual
© 2010, IMI Cornelius Inc. - 25 - Publication Number: 621360041TBSER
17, allows the user to adjust the viscosity in each barrel to the optimum setting
for each type of syrup.
Figure 17. Viscosity Setup Screen
Refer to the Installation manual for the recommended settings based on syrup type.
To set all barrels in the system to the same viscosity setting, perform Steps 1
through 4 in Table 18 and then press the ALL button at the bottom of the display
while highlighting the viscosity setting you desire for all the barrels. When the
viscosity settings are complete, press the BACK button to save the settings and
return to the Select menu, shown in Figure 13.
CO2 Setup Menu
The CO2 Setup menu, shown in Figure 18, allows the user to adjust the percentage of
time that the CO
2 pulse valves are open. This provides an adjustment of the overrun
for the unit when using different syrups. The valves use a one second interval dura-
tion time. Setting a valve to 45 activates the valve for 450 msec. out of each second.
The CO
2 pulse valves may be set between 0 and 100%, in 5% increments. To
change the settings of the CO
2 pulse valves, perform the procedure in Table 19.
Figure 18. CO2 Pulse Valve Setup Screen
Table 18
Step Action Procedure
1
Set viscosity range From the Setup screen (Figure 13), open the Viscos-
ity Setup screen, shown in Figure 17.
2
Select barrel Use the Up and Down arrows to highlight the desired
barrel.
3
Select range field Use Left and Right arrows to select range field
4.
Set range Use the + or - buttons at the bottom of the display to
set the desired range.
5
Select barrel Repeat Steps 2 through 4 for all barrels.
VISC
SETUP
12:51P
MAR 04
#1 VISC RANGE 6 48-110
#2 VISC RANGE 6 48-110
BACK ALL - +
BACK ALL - +
CO2
SETUP
12:51P
MAR 04
#1 CO2 PULSE %: 45
#2 CO2 PULSE % 45
#3 CO2 PULSE % 45