Filter
Top Products
112
7 OPERATION ADJUSTMENT
7.1 Preparation for Operation
Connection with a personal computer
Connect the CPU module with a personal computer on which an engineering tool has been installed.
The system configuration examples and GX Works3 settings are described below.
For details, refer to GX Works3 Operating Manual.
Direct connection
Setting examples for accessing the CPU module that is directly connected with a personal computer are shown below.
■Ethernet connection
• CPU Module Direct Coupled Setting
GX Works3 settings
For the FX5 CPU module, the Ethernet adapter on the personal computer side used for the Ethernet port
direct connection can be specified.
Click the [CPU Module Direct Coupled Setting] button on the "Specify Connection Destination Connection"
window to display the "CPU Module Direct Coupled Setting" window. Select the adapter on the window.
• Connection via HUB
GX Works3 settings
No. Item Selection item Internal setting Input value
1) PC side I/F Ethernet Board
2) PLC side I/F PLC Module Ethernet Port Direct
Connection
Other Station Setting No Specification Check at Communication
Time
30 seconds
Retry Times 0 times
No. Item Selection item Internal setting Input value
1) PC side I/F Ethernet Board
2) PLC side I/F PLC Module Connection via HUB IP Address 192.168.0.2
Response Wait Time 2 seconds
Other Station Setting No Specification Check at Communication Time 30 seconds
Retry Times 0 times
Built-in
Ethernet
1)
2)
Ethernet port
Ethernet cable
Built-in Ethernet
(192.168.0.2)
HUB
1)
2)