Mitsubishi FR-A5AP Oven User Manual


 
14
3.3. Terminals
Symbo
l
Terminal Remarks Description
PA1 PLG A-phase signal input terminal
PA2 PLG A-phase inverse signal input
terminal
PB1 PLG B-phase signal input terminal
PB2 PLG B-phase inverse signal input
terminal
For information on the
pulse signals, refer to
page 11.
A-, B- and C(Z)-phase signals are input
from the PLG
PC1 PLG C(Z)-phase signal input terminal
PC2 PLG C(Z)-phase inverse signal input
terminal
PAR A-phase terminal resistor terminal Factory-connected with "PA2" by the
jumper. Remove the jumper when the
terminal resistor is not needed
PBR B-phase terminal resistor terminal Factory-connected with "PB2" by the
jumper. Remove the jumper when the
terminal resistor is not needed
PCR C(Z)-phase terminal resistor terminal Factory-connected with "PC2" by the
jumper. Remove the jumper when the
terminal resistor is not needed
5V DC power (positive) input terminal
SG DC power ground terminal
4.75 to 6VDC (Current
consumption 50mA)
PLG power supply common terminals.
Input PLG power. Connect the positive
side to 5V and the ground side to SG.
Also, connect the shield of the shield wire
to SG.