Filter
Top Products
6
Safety M odel 5454
131212
by the equipotential bonding symbol (5021 of IEC
60417-1) on both the removable panel and the unit’s
frame.
DO NOT use a water j et to clean or rinse the
unit. Failure to follow these i nstructions may r esult in
serious electrical shock.
S DO NOT allow untrained personnel to
operate this unit.
S DO NOT operat e the unit unless all service
panels and access doors are r estrained with
screws.
S DO NOT remove any internal operating
parts (including, but not limit ed to, freezer
door, beater, o r scraper blades), unless all
control s witches ar e in the OFF position.
Failureto follow these i nstructions may result in s evere
personal injury, especially to fingers or hands, from
hazardous moving parts .
This unit has many sharp edges that can
cause severe injuries.
S DO NOT put objects or fingers in the door
spout. This may contam inate the product
and cause s evere personal injury from blade
contact.
S USE E XTREME CAUTION when removing
the beater assembly. The scraper blades
are v ery sharp.
This unit must be placed on a lev el surface.
Extr eme care should b etakenwhen moving t heunit for
any reason. Two or more persons are required to
safely move this unit. Failure to comply may result in
personal injury or dam age to the unit.
Access to the ser vice area of the unit must be
restr icted to persons having knowledge and practical
experience with the unit, in particular a s far as s afety
and hygiene are c oncerned.
Cleaning and sanitizing schedules are
governed by your state or local regulatory agencies
and must be followed accordingly. P lease refer to the
cleaning section of thisOper ator Manual for the proper
procedure to clean this unit.
This unit is designed to maintain product
temperature under 41_F(5_C). Any product being
added to this unit must be below 41_F(5_C). Failur e
to follow this instruct ion may result in health hazards
and poor freezer performance.
DO NOT obstruc t air intake and discharge openings :
3” (76 mm) minimum air space around all sides, and
12” ( 305 mm ) on top. Failure to follow this instruction
may cause poor freezer performance and damage to
the machine.
For Indoor Use Only: This unit is designed tooperate
indoors, under normal ambient temperatures of
70_-75_F(21_-24_C). The unit has successfully
performed in high ambient temperatures of up to
104_F(40_C) at reduced capacit ies.
DO NOT run the unit without product. Failure to follow
this instruction can result in damage to the unit.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measur ed at a distance of 1.0
meter from thesurface of the unit and at a height of 1.6
meters from the floor.