Filter
Top Products
18
Operat ing Procedures Mod el 5454
Note: The scraper blade must fit securely over the pin
to prevent costly damage.
Figure 8
Assemble the front blade on the beater, and s lide the
beater assembly into the freezing cylinder.
Figure 9
Make sure the beater ass embly is in position over the
drive shaft. Turn the beater s lightly to be certain that
the beater is properly seated. When in position, the
beater will not protr ude beyondthe front of the freezing
cylinder.
Figure 10
Step 3
Assemble the freezer door. Place the freez er door
gasket into the groove on the back of the fr eezer door .
Slide the f ront bearing onto the bearing hub so the
flanged edge isagainst the door. DO NOT lubricate the
gasket or bearing.
Figure 11
Slide the t wo o-rings into the grooves on the prime
plug. Apply an even coat of lubricant to the o-rings and
shaft.
Figure 12