Filter
Top Products
©2001 Maytag Appliances Sales Company
2-3
16010486 (16008373-05)
Revised 02/01
Section 2. Washer Controls Overview
OPTIONS MODE
When the extra rinse key is selected, an
extra rinse is added for the wash cycles.
(Page 1-3 Extra Rinse Table)
When max extract speed key is selected,
the max extract profile will be used for
spin cycle based on the fabric selection.
When the stain cycle key is selected, the
water input temperature, the wash time,
the tumbling pattern, speed, and amount
of rinses may be modified.
When the presoak key is selected, a
presoak is added before the main wash
cycle.
DISPLAY CHARACTERISTICS
Door Locked LED:
When the door is finally locked, the door
locked LED is lit. When the door is finally
unlocked, the door locked LED is not lit.
Two Digit Display:
The display shows the estimated time
remaining in the total cycle in minutes.
This time will count down during the total
time cycle.
If the selected Wash cycle button is
pushed, the estimated time remaining in
that wash cycle shall be displayed for 5
seconds and the associated Wash level
LED will flash. After 5 seconds, the
estimated time remaining for the total
cycle will be displayed and the wash level
LED will return to being on constant.
Changing Selections:
Fabric, temperature, and options
selections may be changed at any time.
The current cycle step will be suspended
and the appropriate cycle step will be
restarted with the new selections. The
machine will not stop, but rather the
changes will be dynamic.
The main Wash Keys may be changed at
any time. The cycle time remaining is
recalculated and displayed. The
remaining time is calculated by applying
the actual time in the new cycle. If the
user had originally selected Heavy wash
and 3 minutes has elapsed and the user
then selects Normal wash, the time
remaining will be 12 minutes. (e.g. 15
minutes Normal wash minus 3 actual
minutes = 12 minutes). If the user had
originally selected Quick wash, 1 minute
had elapsed, and then the user selects
Heavy wash, the new remaining time will
be 19 minutes (20 minutes heavy wash
minus 1 minute actual time).
The main Wash key may not be changed if
there is less than 2 minutes time
remaining in the wash cycle (Bleach Fill).
Although the button can be depressed,
the LED status will change but the time
remaining or wash cycle will not change.
USER INTERFACE SELECTIONS:
(LCD Washer)
All selections described under the LED
washer section are familiar except in the
Delay mode. In this mode, time is
increased in 15 minute increments up to
12 hours.