Filter
Top Products
© 1998 Maytag Corporation
16008373-01 SECTION 4. CONSOLE
4-14-1
4-14-1
4-1
SECTION 4. CONSOLESECTION 4. CONSOLE
SECTION 4. CONSOLESECTION 4. CONSOLE
SECTION 4. CONSOLE
REMOVALREMOVAL
REMOVALREMOVAL
REMOVAL
1.
Disconnect power to the unit.Disconnect power to the unit.
Disconnect power to the unit.Disconnect power to the unit.
Disconnect power to the unit.
2. Remove the three screws securing the con-
sole rear cover plate across the rear top
edge of the console
(Figure 4-1)(Figure 4-1)
(Figure 4-1)(Figure 4-1)
(Figure 4-1)
..
..
.
3 . Lay a drop cloth across the top cover of the
washer.
4. Grasp the top of the console and gently rock
the top forward (
Figure 4-2Figure 4-2
Figure 4-2Figure 4-2
Figure 4-2).
Warning Warning
Warning Warning
Warning
- Always shut off- Always shut off
- Always shut off- Always shut off
- Always shut off
electrical power to the unitelectrical power to the unit
electrical power to the unitelectrical power to the unit
electrical power to the unit
before beginning any servicebefore beginning any service
before beginning any servicebefore beginning any service
before beginning any service
procedure.procedure.
procedure.procedure.
procedure.
Figure 4-2Figure 4-2
Figure 4-2Figure 4-2
Figure 4-2
Figure 4-3Figure 4-3
Figure 4-3Figure 4-3
Figure 4-3
Figure 4-4Figure 4-4
Figure 4-4Figure 4-4
Figure 4-4
Figure 4-1Figure 4-1
Figure 4-1Figure 4-1
Figure 4-1
ConsoleConsole
ConsoleConsole
Console
MountingMounting
MountingMounting
Mounting
ScrewsScrews
ScrewsScrews
Screws
5. Push the bottom of the console toward
the back panel to disengage the six lock-
ing feet from the top cover
(Figure 4-3)(Figure 4-3)
(Figure 4-3)(Figure 4-3)
(Figure 4-3).
6 . Carefully lift and roll the console forward
onto the top cover. You now have access
to the console components and wiring
(Figure 4-4).(Figure 4-4).
(Figure 4-4).(Figure 4-4).
(Figure 4-4).
7.
To Reinstall: To Reinstall:
To Reinstall: To Reinstall:
To Reinstall: Roll the console back into
an upright position, engaging the locking
feet into the slots in the top cover. Re-
place the three screws to attach console
back to rear panel.