Filter
Top Products
© 1998 Maytag Corporation
16008373-01 SECTION 1. GENERAL INFORMATION 1-8
OUTPUT DEFINITIONS
DOOR LOCKED LIGHT OUTPUT
NOTE: This section applies only to washers
between Series 10 and 16. The "Door Locked"
lights on washers from Series 17 and after are
controlled by a "Door Locked" light switch.
The Door Locked Light Output signal powers
a 1/3 watt neon indicator lamp on the control
panel. This output is first energized when the
Door Lock Wax Motor Output is energized. At
the end of the cycle, it remains energized for
50 seconds after the Door Lock Switch Input
shuts down. This delay allows the wax motor
to fully retract and unlock the door.
NOTE: The washer will continue to tumble
at the end of cycle until this 50 second delay
is elapsed.
DOOR LOCK WAX MOTOR OUTPUT
The Door Lock Wax Motor Output signal pow-
ers a wax motor in the door lock assembly.
The wax motor extends to drive the door lock
system for the washer.
If the washer is started with the timer set in a
Prewash Tumble, Main Wash Tumble, or Light
Wash Tumble increment, the machine control
will wait for three minutes before energizing
the Door Lock Wax Motor Output. This delay
is not affected by water level. This output re-
mains energized until the end of the cycle.
If the washer is started with the timer set in a
Prewash Drain, Bleach Dispense, Spin1, Rinse
Tumble, Spin2, or Spin3 increment, the ma-
chine control will energize this output imme-
diately.
The machine control will continuously ener-
gize the Door Lock Wax Motor Output during
the final (Spin 3) sequence until 30 seconds
before the washer begins to coast from the
final speed.
END-OF-CYCLE SIGNAL OUTPUT
The End-Of-Cycle Signal Output is an inter-
nal signal on the machine control between the
microprocessor and annunciator. The end-of-
cycle signal sounds when a wash cycle is fin-
ished and the End-Of-Cycle Input is energized.
The end-of-cycle signal sounds as six pulses
in a 0.35 seconds on, 0.15 seconds off pattern
(See Timer Input Charts).
ON LIGHT OUTPUT
NOTE: This section applies only to washers
from Series 17 and after. The "Door Locked"
lights on washers between Series 10 and 16
are controlled by a cam on the timer.
The Door Locked Light Output signal powers
a 1/3 watt neon indicator lamp on the control
panel. This output is energized when the
washer is operating in a wash or spin cycle.
Note that the "On" light is not illuminated when
the timer is in a delay increment.
TIMER MOTOR OUTPUT
The machine control energizes the Timer
Motor Output to allow for variable-length
timer increments. If the washer is started with
the timer set in a Prewash Tumble, Main Wash
Tumble, Light Wash Tumble, or Rinse Tumble
increment, the machine control will not be-
gin the cycle sequence timing until the water
level reaches the appropriate level. The Timer
Motor Output is disengaged during this time.
The machine control will stop the washer by
disengaging the line relay if the following oc-
cur: 1) The machine control energizes the
timer motor until it senses a timer change. 2)
The timer motor remains energized for five
minutes while the timer inputs change (See
Timer Input Charts).