Filter
Top Products
©2001 Maytag Appliances Sales Company
2-18
16010486 (16008373-05)
Revised 02/01
Section 2. Washer Controls Overview
To toggle outputs,
press PAUSE and select output below
Input Status
door closed
door locked
unbalance detected
wash level (low) speed
rinse level (high) sensed
fill temperature
sump temperature
ambient temperature
RPM
exit system check
Output Status
hot water on
cold water on
bleach valve on
fabic softener on
drain on
motor control
on heat on
cancel cycle
help codes:
1...
2...
3...
4...
5...
6...
7...
8....
9...
Diagnostic/Help
Codes
cycle count
XXXX
diagnostic codes:
1...
2...
3...
4...
5...
6...
7...
8....
9...
software version
XXXX
clear
help codes
exit diagnostic/
help codes
clear
diagnostic codes
SYSTEM CHECK
System checks can be run when the
washer is running a wash cycle or not. If
the washer is not in a wash cycle, the
following screen will display and allow the
technician to toggle various components
On/Off.
At the same time, the screen will display
the current status of the component
inputs to the control board.
If the washer is already running a cycle
and the system check is activated, then
the screen will display the status of all the
outputs and inputs to the control board.
Cancel & exit quick spin test: this
returns you to the service tests screen.
Cancel cycle: This will stop the current
cycle.
Exit system check: This will exit the
system check screen and revert back to
the previous screen shown on the display
panel..
DIAGNOSTIC/HELP CODES
Diagnostic codes: Display all diagnostic
codes.
Help codes: Display all help codes.
Software version: Display current
software version.
Cycle count: Display the cycle count
exit diagnostic/help codes: Return to
previous screen.
Clear diagnostic codes: Clear the entire
list of diagnostic codes.
Clear help codes: Clear the entire list of
help codes.
Software version: Display current
software version
For a listing of available diagnostic and
help codes, see Section 5: DIAGNOSTIC/
HELP CODE TABLES.