Filter
Top Products
©2001 Maytag Appliances Sales Company
2-9
16010486 (16008373-05)
Revised 02/01
Section 2. Washer Controls Overview
MAH5500B:
:devaSnoitamrofnI :esuaC
tsaLehtfogninnigebehT
.demrofreppetselcyc
ssol-rewoP
ecafretnIresUtnerruC
snoitceles
ssol-rewoP
latoteht,sedoccitsongaiD
scitsongaidehtforebmun
rebmuncitsongaidecnis
.deraelcneebsah
derrucconehW
nurselcycforebmunehTafodnE
detelpmoc
.elcychsaw
POWER LOSS/FAILURE
Power-up after a power-loss during a main
wash cycle. The machine cycle will re-
sume at the appropriate cycle step after
the Start/Pause key has been pressed. The
control recovers the saved information on
power-up after a power loss. The recov-
ery will be to the appropriate step in the
cycle and within 3 minutes of the cycle
step where the power loss occurred. The
LCD display will be reset to the appropri-
ate time left after the Start/Pause key has
been pressed and not indicate a power
failure at that point. The main wash cycle
will resume immediately after the Start/
Pause key has been pressed.
When a power loss occurs during the final
spin of a main wash cycle, the cycle will
end, on the MAH5500B. The MAH7500A
will finish the spin cycle.
Power-up after a power-loss during service
mode, continuous mode, or advertising
mode will cancel these modes.
These modes will not resume after the
power-up until the user selections are
pressed again.
If a power outage occurs during a cycle the
washer will come back up in the paused
state. When paused (either by a power
outage or by the user), the washer will
remember where it was. The machine will
not automatically time-out and cancel a
cycle while paused. The display will re-
main on for 10 minutes after it is paused
with no activity. After 10 minutes of no
activity, the display will turn off, but the
machine will remember where it was and
the display will be turned back on with any
user activity.
SPECIAL FEATURES
The LCD and LED washers come with
several new features not available with the
earlier versions of the Neptune washers.
By pressing a combination of keys, the
washer can be placed into an Advertising
Mode or into a Service Mode for the
service technician.
ADVERTISING MODE
This mode will continuously display the
LEDs on the keyboard or illuminate the
LCD touch screen.
MAH7500A:
Continuously monitors and saves infor-
mation to memory every minute or as
cycle selection change.