Filter
Top Products
©2001 Maytag Appliances Sales Company
2-6
16010486 (16008373-05)
Revised 02/01
Section 2. Washer Controls Overview
resU
snoitceleS
retawtupnI
derepmet
mumixaM
noretaeh
emit
-hsaWdloC
retaehon
retawdloC
derepmeT
hsaw
A/N
hsaWdloC
niatshtiw
&noitpoelcyc
.retaeh
taehlliW,F°56
fiF°56otretaw
.yrassecen
niaM
emithsaw
-hsaWmraW
retaehon
retawmraW
derepmeT
mraw
A/N
hsaWmraW
niatshtiw
noitpoelcyc
.retaehdna
taehlliw,F°501
fiF°501ot
yrassecen
niaM
emithsaw
on-hsaWtoH
retaeh
retawtoHA/N
htiwhsaWtoH
dnaelcycniats
.retaeh
neht,retawtoH
fiF°031ottaeh
yrassecen
niaM
emithsaw
below the main wash target temperature.
The heater monitors the water
temperature through the thermistor in the
heater assembly. Selecting the energy
saver, will turn off the heater and will not
affect tumble patterns.
Main Wash Target Temperatures
The heater will not be turned on if the
following conditions exist:
1. Low level of the water pressure switch
is not satisfied.
2. The door is open.
3. During the Bleach fill.
4. Energy Saver on.
DOOR LOCKED LIGHT OUTPUT
The Door Locked Light Output signal
powers a LED on the membrane pad
switch of the LED washer. This output is
energized when the washer door is
locked.
VDC REFERENCE VOLTAGE OUTPUT
The VDC Outputs are a reference voltage
for many of the signal outputs. On the
machine control, the VDC outputs are 24
VDC referenced from P2(3) to the
individual outputs.
WATER VALVE OUTPUTS
The machine control determines whether
the hot or cold Water Valve Outputs
should be energized during the wash
cycle based upon the user selections.
When water fill is required, the machine
control board will activate relays on the
board, supplying power to the water
valves.
The machine control gates the power to
the hot and cold Water Valve Outputs.
When the pressure switch senses that the
full level is reached, the circuit opens and
the machine control de-energizes the
Water Valve Outputs.
The machine control will monitor the
thermistor resistance and fill time to
achieve proper wash temperatures.
During a warm wash the cold may be
cycled off periodically to achieve the
desired water temperature.
On a cold wash the hot valve may be
cycled on and off.
CYCLE SEQUENCE DEFINITIONS
IDLE/PAUSE MODE (LED Model)
After pressing the Off key, the entire
washing machine will shut down after
unlocking the door and will be in the Idle
Mode. In the idle mode all the outputs are
de-energized, all the LEDs and display are
off.