Filter
Top Products
5-2
16010486 (16008373-05)
Revised 10/00
Section 5. Teardown & Wiring Information
©2001 Maytag Appliances Sales Company
4. Remove the four mounting screws
securing the board to the console.
5. Remove the board from the console.
6. Note: To avoid the potential for acci-
dental static discharge damage to the
replacement board, you must be
properly grounded prior to handling
the board. This can be accomplished
by using a special grounded strap tied
on your wrist and grounded to the
product, or simply touching a
grounded source to discharge any
static charge build up on your person.
7. Insert the replacement board into the
console and secure the mounting
bracket to the console.
8. Reattach wire harnesses and mem-
brane pad harness to the replacement
machine control board.
CONSOLE COVER PLUG
The cover plug inserts into the rear of the
console to fill a cavity void in the console.
The plug is secured to the console via a
console screw mounted directly behind it.
The cover plug simply fills a void area in
the console for cosmetic purposes only.
Figure 5-5
CABINET ASSEMBLY
The overall cabinet assembly design is
identical to the MAH4000 washer, except
for the revised door lock mechanism,
door latch hoop and front shroud. for
simplicity reasons, we will address only
the exceptions in this chapter.
DOOR LATCH HOOP
The latch hoop was redesigned, eliminat-
ing the latch hoop support and spring.
REMOVAL
1. Remove the door assembly from the
washer.
2. Dissassemble the door assembly by
removing the outer door panel.
3. Locate the locking tab on the door
latch hoop and pry the tab up.
4. Squeeze the side tabs to disengage
the locating pins on the sides of the
latch hoop from the door liner.
5. Reinstallation is a reversal of the
aforementioned steps.
Figure 5-6