Filter
Top Products
© 1998 Maytag Corporation
16008373-01 SECTION 1. GENERAL INFORMATION
1-3
4. Slide the washer into position and check
the levelness and stability of the washer.
If necessary, slide the washer out of posi-
tion to either raise or lower the leveling
leg as required to level and stabilize the
washer securely on all four legs. Slide the
washer back into position to confirm lev-
elness to the floor. When the washer is
level, tighten the locking nuts up against
the base of the washer. This will secure
the leveling legs in place.
5. Install the rubber feet, found in the instal-
lation package, on all four (4) legs (Figure
1-3).
6. Pull the drain hose vertically to the drain
strap . Then route the drain hose through
the drain hose strap on the back of the
washer and snap into the plastic hook of
the strap.
7. Install gooseneck end of drain hose into
drain standpipe. Be sure the connection
is not airtight between the drain hose and
standpipe. Standpipe must be at least 24"
high. 36" height is recommended.
8. Connect inlet hoses to water supply us-
ing screen washers (found in the installa-
tion package) at faucet connections, with
the domed screen facing the faucet. At-
tach hoses to the faucets and the water
valve.
Figure 1-4
GROUNDING POLARITY CHECKS
The receptacle used for all Maytag products
operating on 120 Volts AC must be properly
grounded and polarized.
The power cord should be equipped with a
three (3) PRONG POLARIZED GROUNDING
PLUG FOR PROTECTION AGAINST SHOCK
HAZARD and should be plugged directly into
a properly grounded and polarized receptacle.
CAUTION: Do not cut or remove the ground-
ing prong from this plug.
It is the responsibility of the person installing
the appliance to ensure it is adequately
grounded and polarized at the point of instal-
lation. Local conditions and requirements
should be taken into consideration. In cases
where only a two (2) prong receptacle is avail-
able, it is the personal responsibility of the
customer to have it replaced with a properly
grounded and polarized three (3) prong recep-
tacle (Figure 1-6).
Figure 1-5
Turn on the water and check for leaks (Figure
1-5). Note the H and C designations on the
water valve bracket for the Hot and Cold
hoses.
NOTE: Accessory inlet hoses are available in
various lengths, up to 10 feet.