Filter
Top Products
© 1998 Maytag Corporation
16008373-01 SECTION 5. CABINET ASSEMBLY
5-5
3. Remove the door
(See Door Assembly and
Hinge Removal).
4. Removal and replacement of the screws
in the following order, as illustrated, is nec-
essary to provide proper alignment of the
parts. Failure to do so will hinder removal
and replacement of the shroud onto the
cabinet
(Figure 5-10)
.
5. Place a soft cloth over the top of the con-
crete weight. Carefully lift and stand the
shroud assembly on top of the tub. The
assembly can lean back against the top
cover. The wire harness on the left side of
the upper cabinet is long enough to do this.
When replacing the shroud, be sure to tuck
the harness inside the upper flange of the
top cover to keep the wires from being
pinched and damaged.
Figure 5-9
Figure 5-10
CABINET ASSEMBLY w/REAR
ACCESS PANEL
Removal of the access panel gains access to
the rear components of the washer
(Figure 5-11)
.
Figure 5-12
REMOVAL
Remove the four hex-head screws surround-
ing the access panel
(Figure 5-12)
.
Figure 5-11
Spacer
Screws
Access Panel