Filter
Top Products
YORK INTERNATIONAL
4
FORM 160.55-O1 (604)
CHANGEABILITY OF THIS DOCUMENT
In complying with YORK’s policy for continuous
prod uct improvement, the information contained in
this doc u ment is subject to change without notice.
While YORK makes no commitment to update or
pro vide current in for ma tion automatically to the
manual own er, that in for ma tion, if applicable, can
be ob tained by con tact ing the nearest YORK Applied
Systems Service ofÞ ce.
It is the responsibility of operating/service personnel
as to the applicability of these documents to the equip-
ment in question. If there is any question in the mind
of op er at ing/service personnel as to the applicability of
these documents, then, prior to working on the equip-
ment, they should verify with the owner wheth er the
equipment has been modiÞ ed and if current lit er a ture
is available.
REFERENCE INSTRUCTIONS
DESCRIPTION FORM NO.
SOLID STATE STARTER (MOD “A”) – OPERATION & MAINTENANCE 160.46-OM3.1
SOLID STATE STARTER (MOD “B”) – OPERATION & MAINTENANCE 160.00-02
VARIABLE SPEED DRIVE – OPERATION 160.00-O1
VARIABLE SPEED DRIVE – SERVICE INSTRUCTIONS 160.00-M1
INSTALLATION 160.55-N1
OPTIVIEW CONTROL CENTER - SERVICE INSTRUCTIONS 160.55-M1
WIRING DIAGRAM – UNIT WITH ELECTRO-MECHANICAL STARTER 160.55-PW1
WIRING DIAGRAM – UNIT WITH SOLID STATE STARTER (MOD “B”) 160.55-PW2
WIRING DIAGRAM – UNIT WITH VARIABLE SPEED DRIVE 160.55-PW3
RENEWAL PARTS – UNIT 160.48-RP5
RENEWAL PARTS – GRAPHIC CONTROL CENTER 160.55-RP1
NOMENCLATURE
The model number denotes the following characteristics of the unit
YT K3 C4 E2 — CR J
Model Design Level
Cooler Code Motor Code
Condenser Code Power Supply
— for 60 Hz
Compressor Code 5 for 50 Hz