GL-1010 Administrator’s Guide 35
n If the Infrastructure network type was selected, configure any
of the network protocols as needed
n If the Ad Hoc network type was selected and the TCP/IP
protocol is to be used, select
MANUAL
M Set the static IP address to 192.168.2.2, Subnet Mask to
255.255.255.0 and Default Gateway to 0.0.0.0. The con-
necting client should have a IP address of 192.168.2.x
and same Subnet Mask and workgroup as the controller
10 Reboot the controller.
11 Perform a test print.
Troubleshooting
Enabling networking on both cards simultaneously
The embedded NIC is connected to the LAN and the wireless
NIC is configured for Ad Hoc (peer-to-peer).
1 If the wireless NIC is already installed, go to step 6.
2 Shutdown the Controller.
3 Install the wireless NIC in Slot 1.
4 Turn the controller on.
5 Press FACTORY DEFAULT in the Admin tab of the copier front
panel and reboot the controller. Wait until the controller
prints a Startup Page before you continue.
6 Configure the wireless networking on the Cisco card via the
ADMIN>WIRELESS SETTINGS button on the front panel.
n Select NETBEUI and select DISABLE (press NO if asked to
reboot)
