GL-1010 Administrator’s Guide 37
n To use APPLETALK, Select APPLETALK and select ENABLE (press
NO when asked to reboot)
n To use TCP/IP, select MANUAL
M Set the static IP address to 192.168.2.2, Subnet Mask to
255.255.255.0 and Default Gateway to 0.0.0.0. The con-
necting client should have a IP address of 192.168.2.x
and same Subnet Mask and workgroup as the controller
14 Reboot the controller.
15 Perform a test print for both the wired and wireless
configurations.
Uninstalling the wireless card and enabling the wired
networking
1 Power down the controller.
2 Remove the wireless NIC.
3 Attach the network cable to the controller.
4 Power up the controller.
5 Press FACTORY DEFAULT in the Admin tab of copier front
panel and reboot the controller. Wait until the controller
prints a Startup Page before you continue.
6 Configure the Networking on the controller via the
ADMIN>NETWORK SETTING button.
7 Perform a test print.
Switching to wired networking without removing the
wireless card
1 Attach the network cable to the controller.
2 Disable wireless networking via the ADMIN>WIRELESS button
on the front panel.
n Select NETBEUI and select DISABLE (press NO if asked to
reboot)
n Select IPX/SPX and select DISABLE (press NO if asked to
reboot)
n Select APPLETALK and select DISABLE (press NO when asked to
reboot)
n Disable TCP/IP
