GL-1010 Administrator’s Guide 39
5 Configure the wireless networking on the Cisco card via the
ADMIN>WIRELESS SETTINGS button on the front panel. The
wireless NIC is currently in DHCP mode.
n If the Infrastructure network type was selected, configure any
of the network protocols as needed
n If the Ad Hoc network type was selected and the TCP/IP
protocol is to be used, select
MANUAL
M Set the static IP address to 192.168.2.2, Subnet Mask to
255.255.255.0 and Default Gateway to 0.0.0.0. The con-
necting client should have a IP address of 192.168.2.x
and same Subnet Mask and workgroup as the controller
6 Reboot the controller.
7 Perform a test print.
Wireless Values
The following table shows the User Interface controls to
configure the wireless options from the front panel and the
TopAccess Web Administration Page.
