36 GL-1010 Administrator’s Guide
n
Select IPX/SPX and select DISABLE (press NO if asked to
reboot)
n Select APPLETALK and select DISABLE (press NO when asked to
reboot)
n Select TCP/IP and select MANUAL
M Set the static IP address to 0.0.0.0, Subnet Mask to
0.0.0.0 and Default Gateway to 0.0.0.0
7 Configure Wi-Fi for Ad Hoc.
8 Reboot the controller.
9 Configure the wired networking on the controller via the
ADMIN>NETWORK SETTING button on the front panel.
n Select NETBEUI and select ENABLE (press NO if asked to
reboot)
n Select IPX/SPX and select ENABLE (press NO if asked to
reboot)
n Select APPLETALK and select ENABLE (press NO when asked to
reboot)
n Select TCP/IP and select MANUAL
M Set the static IP address to 192.168.2.1, Subnet Mask to
255.255.255.0 and Default Gateway to 0.0.0.0
10 Reboot the controller.
11 Configure the wired networking on the controller via the
ADMIN>NETWORK SETTING button on the front panel.
n Select TCP/IP
M For a fixed IP address, set a valid static IP address, Sub-
net Mask, Default Gateway, DNS and WINS servers
accordingly. If DHCP is desired, press DHCP
n If desired, disable any of the other protocols as needed
12 Reboot the controller.
13 Configure the wireless networking on the Cisco card via the
ADMIN>WIRELESS SETTINGS button on the front panel.
n To use NETBEUI, select NETBEUI and select ENABLE (press NO
if asked to reboot)
n To use IPX/SPX, Select IPX/SPX and select ENABLE (press NO
if asked to reboot)
