Filter
Top Products
27
Model PH61 Operating Procedures
Step 6
Place the freezer door o-ring into the groove on the
back of the freezer door. DO NOT lubricate the
o-ring. Lubricate the outside diameter of the front
bearing. Slide the front bearing into the door hub.
(See Figure 12.)
11272
Figure 12
Step 7
Position the freezer door on the 4 studs on the front
of the freezing cylinder. Install the handscrews.
Tighten equally in a criss-cross pattern to insure the
door is snug. Do not over-tighten. (See Figure 13.)
Figure 13
Step 8
Assemble the draw valve spinner assembly. Inspect
draw valve o-rings for cuts or nicks. (Replace if cut
or nicked.) If draw valve o-rings are in good
condition, slide the 2 o-rings into the grooves of the
draw valve and lubricate. (See Figure 14.)
Figure 14
Step 9
Lubricate the outer diameter of the spinner shaft
seal. Fill the cups on each end of the seal with
lubricant. Insert the spinner shaft seal into the
bottom of the draw valve as far as it will go. The
spinner shaft seal should fit into the seal groove
located inside the draw valve cavity.
Important: Inspect to see that the spinner shaft
seal is correctly installed in the groove. A worn,
missing, or improperly installed spinner shaft seal
will cause product leakage out the top of the draw
valve. (See Figure 15)
11062
Figure 15