Filter
Top Products
31
Model PH61 Operating Procedures
Step 3
Apply a thin layer of lubricant to the inside of the
pump cylinder at the retaining pin hole end.
(See Figure 28.)
15130
L
U
B
E
R
Figure 28
Step 4
Insert the piston into the retaining pin hole end of the
pump cylinder. (See Figure 29.)
15118
Figure 29
Step 5
Assemble the valve cap. Slide the red o-ring into the
groove of the valve cap. DO NOT lubricate the
o-ring. (See Figure 30.)
15109
Figure 30
Step 6
Slide the pump valve gasket into the holes on the
cap. DO NOT lubricate the gasket. (See Figure 31.)
15110
Figure 31