Filter
Top Products
32
Model PH61Operating Procedures
Step 7
Insert the valve cap into the hole in the mix inlet
adapter. (See Figure 32.)
Figure 32
Step 8
Insert the mix inlet assembly into the pump cylinder.
(See Figure 33.)
Figure 33
Note: The adapter must be positioned into the
notch located at the end of the pump cylinder.
Step 9
Secure the pump parts in position by sliding the
retaining pin through the cross holes located at one
end of the pump cylinder. (See Figure 34.)
Figure 34
Note: The head of the retaining pin should located
at the top of the pump when installed.
Step 10
Assemble the feed tube assembly. Slide the check
ring into the groove of the feed tube.
(See Figure 35.)
15120
Figure 35