![](http://pdfasset.owneriq.net/3/06/30625994-274b-461e-9ce1-730b412b5019/30625994-274b-461e-9ce1-730b412b5019-bg11.png)
13
Step 8. Hot fresh crusty bread
When the bread is finished baking, the
SmartBake Custom will beep and “0:00”
will appear in the LCD window. A red light
located on the control panel, will flash for
approximately 15-20 minutes.
Once the red light has stopped flashing,
using oven mitts, remove the baking pan
from the baking chamber by lifting it straight
up. Note: the bread pan and loaf are very
hot. Be careful not to place these on any
heat sensitive surface that may scorch.
Allow the bread to cool in the bread pan for
10 minutes before removing. Then with the
oven mitts tap the sides and base of the
baking pan and turn upside down and gently
shake until the bread slides out. If necessary,
use a plastic spatula to loosen bread from
the side of the pan. Place the bread on a
wire rack and allow the bread to cool. We
recommend that sufficient cooling time is
approximately 15 minutes to ensure optimum
bread texture and this also makes slicing
easier.
Keep Warm
If the bread is not removed immediately
after baking and PAUSE is not pressed, the
SmartBake Custom will automatically switch
to a Keep Warm cycle for 60 minutes. Warm
air will circulate throughout the baking
chamber to help reduce condensation.
After 60 minutes on Keep Warm cycle, the
machine will beep and the machine will
go to a standby mode. The bread can be
removed from the baking chamber at the end
of the baking cycle or any time during the
Keep Warm cycle. Simply press the PAUSE
button for 3 seconds to end the Keep Warm
period and turn off the bread maker at the
powerpoint. Note: Keep Warm does not apply
to the Pasta Dough and Pizza Dough menus.
After using your SmartBake Custom
Unplug the machine and allow it to
cool for 30 minutes before commencing
another program. If you attempt to use the
SmartBake Custom too soon, it may beep
and the display will read ‘E:01’, indicating
the SmartBake Custom has not cooled
sufficiently. Wait until the SmartBake Custom
has cooled and then press START.
Tip: The screen will change to sleep mode
after 20 minutes, and the screen will darken.
Push any button to light up the screen again.
Using your SmartBake
®
Custom continued