Filter
Top Products
66
You will hear a beep when:
Program Setting Times and
Display Information
The LCD window will tell you if there is a
problem with your SmartBake CUSTOM.
Always use your SmartBake CUSTOM in
a room free of drafts. Do not use your
SmartBake CUSTOM outdoors, near a heat
vent or in direct sunlight.
DISPLAY READS PROBLEM SOLUTION
“0:00” (:) flashing Select program setting Use the Menu button to
select program.
“E:01” flashing The baking chamber is too Open the lid and remove
hot to begin another cycle bread pan to cool the chamber.
After the panel message disappears,
put the bread pan back into the
chamber and press START again.
“E:02” flashing Sensor malfunction
“E:03” flashing Sensor malfunction
“E:04” flashing CPU malfunction
“E:05” flashing Heater control malfunction
“E:08” flashing Heater control malfunction
The power is turned ON Long beep
Select a setting from the Menu Short beep
Completion of bread baking process Short and Long beeps
Allow the baking chamber
to cool, then restart your
programming. If the error
continues contact Customer
Service on
Australia 1300 881 861.
New Zealand 0800 786 232
Note: After baking a loaf of bread, it is recommended to cool the breadmaker down to room
temperature as temperatures above ambient reduce the rising height of the bread due to the
sensitivity of yeast.
Tip: Display Window Sleep Mode. The Screen will change to sleep mode after 20 minutes and
the screen will darken. Push any button to light up the screen again.