Filter
Top Products
21
When programming you can either adapt and
customise one of the existing preset menus
or you can start from scratch. To customise
an existing preset menu, start at step 1
below. To program your own recipe from
scratch, press the FAVOURITE button, and
start at Step 3 below.
1. Press the FAVOURITE button.
2. To customise an existing menu, select from
one of the existing menus from (1) to (8).
This will be the basis of your new recipe.
Simply press the MENU button to cycle
through the menus.
Note: Refer to the Program Setting Times
chart on page 64, so you can choose the
most appropriate menu.
3. To commence programming press the
CUSTOM button for 2 seconds.
The control panel will beep once,
CUSTOM FAVOURITE will show on the
LCD window and the first stage of the
breadmaking cycle - Preheat will flash.
4. To adjust times press the
buttons.
When you have selected the desired time,
press the CUSTOM button to move to the
next stage of the breadmaking cycle.
Then press the
buttons again to
select your desired times. Repeat this until
all times have been entered. When you
have programmed the times for all stages
ending in the KEEP WARM stage, press the
CUSTOM button to finalise your favourite
menu.
Note: The process is completed when
a longer double beep is heard, FAV will
flash on the LCD window and the total
breadmaking cycle time is displayed.
5. Once you have finished programming, you
can either save your recipe now, by simply
pressing the SAVE button, FAV will stop
flashing and the control panel will beep 3
times.
Your recipe has now been saved into one of
the 8 Favourite Recipe slots.
OR
You can test your recipe first, without yet
saving it by simply pressing START. If you
then want to save the recipe you must ensure
that you press SAVE during but before the
end of the KEEP WARM mode.
Note: You can not save the recipe once the
Keep Warm cycle is complete.
6. To cancel the programming process at any
stage simple press the CANCEL button.
Changing a Favourite Recipe
You can make changes to, or replace any of
your saved Favourite Recipes at any time.
1. Select the recipe you wish to modify by
pressing the FAVOURITE button. This
will allow you to scroll through Favourite
Recipes (1) to (8).
2. To commence programming press the
CUSTOM button for 2 seconds.
The control panel will beep once and the first
stage of the breadmaking cycle - Preheat
will flash.
You can now follow the instructions as
given in the programming section,
steps 3 - 5.
Programming your SmartBake Custom - continued