Filter
Top Products
ETEP Configuration
316 EncrypTight User Guide
NOTE
The coldStart and notifyShutdown traps are always generated, even when Generic traps are disabled.
Related topics:
● “SNMPv2 Trap Hosts” on page 316
● “SNMPv3” on page 316
SNMPv2 Trap Hosts
After selecting the traps that the ETEP will generate, specify the IP address of the trap hosts that will
receive the traps. All of the selected traps are sent to the defined trap hosts. Traps cannot be configured
on a per-host basis.
To configure a trap host:
1 Under Trap Hosts, click Add.
2In the Trap Host dialog box, enter the trap host’s IP Address and then click OK. Traps that are
enabled on the appliance will be sent to the designated host. Traps are enabled at the appliance level;
they cannot be enabled or disabled at the host level.
With ETEP software version 1.6 and later, you can use either IPv4 or IPv6 addresses.
3 To finish configuring trap hosts, do one of the following:
● Click Add to add another trap host.
● Click Modify to edit the trap host IP address or traps.
● Click Delete to remove a trap host.
Related topics:
● “IPv6 Addressing” on page 304
● “Community Strings” on page 314
SNMPv3
ETEP version 1.6 and later includes support for SNMPv3, in addition to SNMPv2c. You can use either
version of SNMP, or both simultaneously.
SNMPv3 enhances security by adding authentication and encryption features.