Filter
Top Products
Maintenance
28
Deliming
To set th e del iming inte rval :
1. Remove power from the appliance.
2. Remove the two screws located on the side
panel. Slide the control module forward. See
Figure 12.
3. T urn the potentiometer to the required setting.
See Figure 13.
4. Slide the control back in, replace the two
screws.
5. Apply power to the appliance.
A PC may be connected a t power up of the ap-
pliance to verify the potentiometer setting. The “De-
liming interval is x hour(s) of steam generator run
time.” Status line will show 30, 60 or 90. Refer to
Figure 15 on page 29.
Figure 12
Figure 13
Setting A
Setting C
Setting B
Potentiometer Settings
TP4
Figure 14