Filter
Top Products
Change LID Configuration If Necessary
The LID Configuration screen is used to view or modify the LID CCN address, change to
English or SI units, and to change the password. If there is more than one machine at the job-
site, change the LID address on each machine so that each machine has its own address. Note
and record the new address. Change the screen to SI units as required, and change the
password if desired. A copy of the password should be retained for future reference.
Modify Controller Identification If Necessary
The controller identification screen is used to change the PSIO module address. Change this
address for each machine if there is more than one machine at the job-site. Write the new
address on the PSIO module for future reference.
Input Equipment Service Parameters If Necessary
The Equipment Service table has 3 service tables: Service1, Service2, and Service3.