Filter
Top Products
solvent such as inhibited methyl chloroform may be used, but must be used sparingly and
immediately removed. While this solvent is non-flammable under ordinary conditions, it is toxic
and proper health and safety precautions should be followed while using it.
Solvents of any type should never be used on windings provided with abrasion protection.
Abrasion protection is a grey, rubber-like coating applied to the winding end-turns.
Adequate ventilation must always be provided in any area where solvents are
being used to avoid the danger of fire, explosion or health hazards. In confined
areas (such as pits) each operator should be provided with an air line respirator, a
hose mask or a self-contained breathing apparatus. Operators should wear gog-
gles, aprons and suitable gloves. Solvents and their vapors should never be
exposed to open flames or sparks and should always be stored in approved
safety containers.
WARNING
!
WARNING