Filter
Top Products
Model 500/600
1207 2-13
Step 4
2-15. CHECKING THE
FILTER PUMP
Use the following testing procedure on new or cold fryers.
1. Open the front door of the fryer.
2. Loosen the filter union connection.
3. Turn the main power switch to the PUMP position.
Open the filter valve. You will hear the electric
motor running.
Only run the pump for a few seconds or damage to the
pump could result.
4. Place your thumb over the open filter union flare. You should feel
suction. Close the filter valve. Turn off the pump.
2-16. MOTOR BEARINGS
The electric motor bearings are permanently lubricated. DO NOT
LUBRICATE.
This completes the testing cycle. If any of the functions did not occur,
recheck the installation. If a problem persists, refer to other sections of
this manual or call an authorized Henny Penny distributor.
2-17. OPERATIONAL
CHECKS
1. Check to see that the indicator needle in the pressure gauge is
reading in the Operating Zone.
• If pressure does not build, contact your local Henny
Penny service office.
2. Check the drain valve and filter valve for leaks.
3. At the end of cook cycle:
• The timer will sound.
• The fryer automatically depressurizes.