Filter
Top Products
Model 500/600
Reversing the lid gasket helps to prevent early failure of lid gasket
and the loss of pressure during a cook cycle.
1. Back the 4 lid liner screws (2 on each side) out about 1/2 inch
(12.7 mm).
2. Using a thin blade screwdriver pry out the gasket at the corners,
and then pull gasket from lid.
Check the gasket for any tears or nicks. If the
gasket is damaged, it needs to be replaced.
3. Clean the gasket and gasket seat with hot water and cleaning
detergent. Rinse with clean hot water.
4. Install the gasket with the “good” side out and tighten the 4
screws.
Install the four corners of the lid gasket. Smooth
the gasket into place, working from the corners
towards the middle of each side.
1207 3-27
3-14. REVERSING THE
LID GASKET