Filter
Top Products
Model 500/600
The Special Program Mode is used to set more detailed
parameters listed below.
• Degrees Fahrenheit or Celsius
• System Initialization
• Program Lock or Unlock
• Fryer Type
• CPU Temperature
• Inputs Status
(high limit, drain switch, fan switch, module)
• Outputs Status (fan, module, heat, pressure)
1. Press and hold while turning on the COOK/PUMP
switch. “SPEC PROG” show in the displays, followed by:
2. “DEG
o
F or
o
C” Press the to change
o
F to
o
C, or vice
versa.
Press to proceed to the next step.
To exit from the Special Program Mode at any time, press and
hold for 2 seconds
3. “INIT —>” shows in the display. Press and hold
to reset the controls to factory settings. Display shows “In-3”,
“In-2”, “In-1”, followed by “INIT SYS” and then “DONE”.
Press to proceed to the next step.
4. “PROG UNLK” or “PROG LOCK” show in the displays.
Press to change controls from “UNLK” to “LOCK”
or vice versa. In the lock mode, the time and temperature can’t
be changed until the controls are unlocked.
Press to proceed to the next step.
4-3. SPECIAL PROGRAM
MODE
1207 4-2